3D Process Blog

  My idea for my Moth Man clock is pretty simple. I want to make custom hands on a clock that look like moth antennae. I also am thinking of using an engraved plastic to make two flat ends and sandwich the extra parts together. The front will be the moth with the eyes cut out and the back will be the back of the moth that will hold the clock mechanism.  I'm hoping to use clear red acrylic for the eyes and insert them into the slots to give it a special sort of effect. If that is possible, I want to install a clear acrylic in the front of the clock to protect the hands.  I kind of want a layered paper effect. I think modeling the moth's pudgy body will be a bit of a challenge in Rhino, but I think if I use subdivision on the model, it will hopefully lead to a more organic looking model.

  The overall shape of all my clocks are relatively similar. I also hope that I can use multiple colors of resin or different  colored .plastics to piece together a clock for added definition. This is my least inspired page. For the heart clock I thought it'd be cool if I could engrave a piece of clear plastic with the time and then put a cut out of a anatomical heart in the center. It'd be simple looking, but I think it'd be sleek and stylish. The "Nessie" clock is also similar in execution, but it is my least favorite one. I think it looks really ugly, but that's why it stays in my roughs. The moth man clock on the top right is my favorite idea. I wanna see if I can cut out this shape and place a clock in the center. If I can't cut out multiple pieces I can always paint parts of the clock if needed.  The "angel halo" clock is based off of one of my character's Dove. Honestly, it's too simple for me to consider it a fun project, and whil...

       Paper Cut Out Draft: After drafting out my copper cut out. I immediately noticed some parts of my project that I want fixed. Firstly, the stand does work, once I use actual copper for my project it will work, and I think it looks really really nice.  Now everything else needs some changes. Firstly, I need to set the notches that holds an item rests a bit more forwards as the idea of the head leaning on the stand does not work, the stand props the card too high and is unstable. Next, I also made the wave cut outs slightly smaller, especially the small details as I'm worried that when I'm folding my copper project the waves will get distorted due to the narrow space.  I also need to use grasshopper to help make the dotted lines actually dotted and test if it will cut on the water jet cutter whenever I do that.  I managed to figure the code out after some struggling and my project should be good for cutting tomorrow.